Operation Manual

32 V0913 NX SERIES
– English
feeder system, as the kick back usually happens whilst working with the spindle fence when only a part
of the piece is machined.
Clean apparatus make adjustment easier. Fences in a perfect state are advisable for quality work.
Therefore, they should be replaced when the edge or surface is damaged by the spindle tool.
Adjustments (g. 20)
3 adjustments have to be made:
– Adjustments of the spindle fences as close as possible tot the outer tool diameter, and adjustment
of the depth of cut.
– Adjustments of the vertical pusher according to the height of the work piece
– Adjustments of the horizontal pusher according to the width of the work piece
– There can ‘t be too much pressure on the pushers, so the wood can slide easily between the wood
pushers and the fences
Important:
Before starting the spindle, all locks and settings should be checked, and check manually if the tools
can rotate freely. Always use the supplied wood pushers on the fence. This upper cover plate is used as
protection of the upper part of the spindle tool.
Fig.19
Fig.20
1
2
1
3
Vertical pusher
Horizontal pusher
Wood pusher