Operation Manual

34 V0913 NX SERIES

– English

straight part of the template. The cutting depth is progressive; with a maximum on the index of the

template (hat index is visible through the horizontal pusher. The wood guide, connected to the fence,

replaces the template when calibrating with a bearing. The operator is obliged to use this guide which

is delivered with the fence. It is thus advisable to adjust the wood pusher height using as a guide and

to put it as far to the front as possible.

Tenoning guard option A4375

and tenoning table option A4276 (g.23)

1 For tenoning, a special guard is mounted on the table.

2 This guard allows tools up to 250 mm diameter.

3 The hood (1) is ﬁxed to the table with two 2 clamp screws (1)

4 The front cover plate (3) is adjustable in height with 2 knobs (2) at the top of the hood.

5 When tools up to 220 or 250 mm diameter are used, the speed of the spindle arbour has to be

3000 T/min.

Fig.23

Thicknesser - planer - mortiser

Warning

1 Always make sure there is no tool left in the mortising chuck before starting up the planer-

thicknesser.

2 Check very carefully whether the planer knives are well positioned and fastened. If this is not the

case, they will come off when the machine is started and this could lead to serious injuries for the

operator and damage the machine.

Changing and setting of the planer knives (g. 24)

1 Unlock the bolts (1) in the jib strip and remove the planer knives

2 Remove the 3 jib strips and clean the grooves inside the planer arbor. Make sure the little springs

(2) underneath the knives do not stay blocked inside their seats in the arbor

3 Never use planer knives which have less than 20 mm height

4 Put the cleaned planer knife (3) into the groove with the adjustment gauge (X428)

5 Tighten the bolts from the middle of the arbour to the outside

6 Do a trial run of the machine and then tighten the knives again.

tenoning table

Option A4376