Operation Manual

NX SERIES V0913 35
– English
Adjustment of the planer tables (g. 25)
1 The out feed planer table has to be set at exactly the same height as the planer knives.
2 A simple way of checking the correct height of this out feed table is to put a 100 % straight piece
of wood onto the out feed table, just above the planer knives. Both tables have a clamp handle
(1) and an adjustment knob (2).
3 To adjust the table in height, use the adjustment knob (2)
4 During this adjustment, turn the planer arbor by hand and see if the planer knife touches the
piece of wood.
5 After the adjustment in height the table has to be blocked again.
6 The chip removal is adjusted through the height of the in feed table and can be max. 4 mm.
7 After the adjustment, block the table again.
8 The opening of the table happens by means of loosening the handles and opening the tables.
9 The tables are automatically protected from falling by the protection lever. To close the table,
simply flip over the piece and gently close the table.
Fig.25 A Fig.25 B