Operation Manual

36 V0913 NX SERIES

– English

Planer fence (g. 26,27)

1 The planer can be adjusted according to the width of the work piece after unlocking

the handle (1)

2 After unlocking the clamping handle (2) the fence can be set at 45° and 90°.

The adjustment screw for position 90° is at the bottom of the clamping plate.

The adjustment screw for position 45° is at the upper side of the clamping plate.

Fig.26

Planer protection (g. 27, 28 en 29)

The planer protection is composed of an aluminium protection bridge which can be adjusted in height

parallel to the planer arbor and tables at 100 mm maximum. For surface planing the bridge (1) has

to be lowered by means of the adjustment knob (g. 28.1). This position is not inexible. Thanks to

the atted, bulged shape of the bridge, the work piece can be pushed over the planer in one uent

movement. That way, tracks of retaking are avoided. Move the bridge sideways by loosening the knob

(g. 28.1

This protection has to be set in place for every operation on the planer.

Set the height with the adjustment knob, the work piece is guided along the planer fence. First check

the work piece for straightness and always put the work piece with the concave down. Then set the

chip thickness by adjusting the in feed table. For planing the narrow side of a work piece the protection

bridge has to be lowered to the table and has to be set according to the work piece width. Set the

protection bridge with a minimal opening to the work piece to ensure maximum cover and safety. To

clear the planer protection from the tables, unlock the handle and swing the complete protection to the

back.

Fig.27 Fig.28