Operation Manual

– English – Deutsch
NZ3200 - AXIS ERGO V1110 15
Mounting of the cross-cut table (Fig.17)
The cross-cut table can be installed onto the sliding table, putting it in the notch at the back of the
sliding table. The xation of the cross-cut table can be done with the handles (2) and the telescopic
arm. The machine serves only to put the cross-cut table at the back of the sliding table. To place this
cross-cut table at the front of this sliding table, with a maximum at the centre, a longer tube for the
telescopic arm is needed. (option: tube of 2.5 m: Z482)
Mounting of the cross-cut fence (Fig.18)
The cross-cut fence has got a cone and the cross-cut table has got an attachment hole. To position the
supported guide onto the cross-cut table, place the fence with the pin into the attachment hole on the
front of the table.
Place the serrated knob (1) in order to attach it to the table.
Turn the adjustment bolts to the left or right in order to move the guide backwards or forwards to obtain
a good alignment to the main blade.
After these adjustments, tighten well the both bolts. The cross-cut fence can be used in different
positions at the front, back or inclined.
Fig.17
Fig.18