Operation Manual

– English – Deutsch
24 V1110 NZ3200 - AXIS ERGO
MOUNTING INSTRUCTIONS FOR PANELSAW Z SERIE
Put the digital read-out onto the parallel fence support block using the 2 holes already
drilled. On older machines these 2 holes need to be drilled. Now put the alu prole holding the
magnetic strip onto the saw table at 1 mm below the table’s front edge.
Make sure the sensor is put in the middle of the magnetic strip and the distance between strip and
sensor is set at 0,5 to 1 mm maximum.
Make sure the sensor stays at 0,5 to 1 mm over the entire length of the magnetic strip.
0,5 - 1mm max