Operation Manual

20 V0212 HX SERIES

– English

– Deutsch

Fig.11

Attention: cleaning and maintenance of the sliding table

It is essential to frequently blow away the accumulated shavings and dust, between the two

parts of the sliding table and the ball bearing. Push the sliding table to the end of the course

to get better access to the rails, the ball bearing and the slides of the sliding table. Repeat

this, with the sliding table moved to the other side, to be sure all shavings and dust is gone.

A normal lubricant such as WD-40 is sufficient to grease the slides of the sliding table and to

obtain good functioning.

ADJUSTMENT OF THE SLIDING TABLE (g. 12)

The alignment between the sliding table can be adjusted by means of the 2 adjustment points below

the ﬁxed beam of the sliding table. Loosen the 2 screws (2) that hold the ﬁxed beam on the chassis

of the machine. Loosen the 2 bolts (1) and align by moving the sliding table. After the adjustments,

tighten the 2 bolts. The adjustment of the sliding table against the cast iron saw table is made by

means of the 2 bolts (1).

Fig.12