Operation Manual

HX SERIES V0212 31
– English – Deutsch
Important
A smooth table surface is essential for good operation of the thicknesser. Therefore the table should be
cleaned and rubbed in with normal cheap whit paraffin wax regularly. A roller support should be used
when long work pieces have to be machined.
Fig.30
Mortiser
Warning:
1 Always make sure both the mortiser chuck and the planer arbor safety guards are in place before
starting work.
2 Only use left hand drill bits and whenever possible short drills.
3 Make sure the drill bit is fastened correctly.
4 Make sure the work piece is firmly secured onto the table with the wood clamp.
5 An adjustable work piece support can be fitted onto the mortising table.
Putting the mortiser unit onto the frame (fig. 31)
1 Clean both mounting surfaces (1).
2 Slide the unit onto the two bolts (3).
3 Make sure the table is mounted horizontally before tightening the two bolts (3).
Fig.31
Height adjustement (fig. 32)
1 De hoogte van de boortafel kan afgesteld worden d.m.v. het handwiel (1). Blokkeer de tafel met
het hendeltje (2). Één omwenteling staat gelijk aan een aanpassing van 4mm.
2 D.m.v. de 2 hefbomen op de tafel kan deze in alle richtingen worden bewogen.
3 De langsbeweging gebeurt met hefboom (3), de dwarsbeweging met de hefboom (4).
4
1
2
3
1
2