Operation Manual

34 V0212 HX SERIES
– English
– Deutsch
Fig.36
The spindle belts can be tensioned, or changed, simply by loosening the 2 bolts holding the motor
support plate to the spindle column (1).
Pull the motor towards you for tensioning the belts.
For replacing them, the motor must be taken-off of the column.
The drive chain for the feeding system on the thicknesser can very easily be lubricated by opening
the planer in feed table. Now the drive chain can be seen right next to the planer table locking bolt.
The little cover plate X0164 can be removed by removing the table locking bolt. When however the
chain has to be replaced, then the complete saw spindle table has to be taken off to reach this chain.
Fig.37
1
1