Instructions for use

4 OPERATION

A - EXTRACTION OR RECYCLING :Your cooker hood is supplied in the extraction mode. To use the cooker

hood in the recycling mode re-programme the hood as follows:

Starting in the recycling mode (the contaminated air passes into the hood through the grease lters and

the purifying activated charcoal lter and back out into the kitchen through grilles).

Press the ‘+’ button (while the motor and lights are switched ‘OFF’) until the ve LED lights will ash twice

to indicate conrmation that the cooker hood is in the recycling mode.

Reverting to the extraction mode (The cooker hood is ducted to the outside).

Press the ‘+’ button (while the motor and lights are switched ‘OFF’) until the ve LED lights will ash once

to indicate conrmation that the cooker hood is in the extraction mode.

B - BASIC INSTRUCTIONS

Lighting

Press LED button 1 to switch ‘ON’ the lights and the LED will illuminate to conrm the lights are switched

‘ON’.

Motor

Press LED button 2 to switch ‘ON’ the fan motor (and adjust the speed of the fan motor by pressing the

LED button ‘+’ and ‘-‘) and the LED lights 2, 3 and 4 will illuminate. The fan speed will be increased if

constant pressure is kept on the (+) button.

LED 2 : Minimum speed - cooking with one pan or simmering

LED 2 & 3 : Medium speed - normal cooking with up to 4 pans

LED 2, 3 & 4 : Maximum speed - frying and cooking foods with strong odours

Press LED button 5 to obtain the boost position for maximum effect and the LED will illuminate to conrm

fan is switched ‘ON’.

C - COMPLEMENTARY INSTRUCTIONS

• Boost speed :

To obtain the best performance it is advisable to switch ‘ON’ the cooker hood a few minutes (in the boost

setting) before you start cooking. To program the complementary function, proceed as follows:

- Press LED button 2 to switch ‘ON’ the fan motor and adjust the speed of the fan by pressing the LED

button ‘+’ and ‘-‘. You should keep applying pressure to the ‘+’ and ‘-‘ button until the required speed is

selected.

- Press LED button 5 (boost speed) to switch ‘ON’ the fan motor in the boost setting. Press LED button 5

to switch ‘OFF’ the boost setting immediately.

It is advisable too that you should leave it running in the boost setting for approximately 5 minutes after

nishing.

• Pre-set stop of the boost speed :

A pre-set stop after 5 minutes of the boost speed is available.

Your cooker hood is supplied with a deactivated pre-set stop of the boost speed. To use the cooker hood