User Manual

29
Specify if your printer has a fan.
Has Heated Bed:
Specify if your printer has a heated bed.
Has SD Card Reader:
Specify if your printer has the ability to plug in an SD card.
Z Can Be Negative:
Lets the bed leveling code know if the printer can support the z axis going below 0. A
printer with min z end stops or software end stops may not be able to.
Default=unchecked.
G Code Output:
Some firmwares use different g and m codes. Setting this ensures that the output gcode
will use the correct commands. R1 utilizes RepRap gcodes.
Custom G-Code
Start G-Code:
This gocde will be inserted into the output gcode file right after the temperature setting.
End G-Code:
This gcode will be inserted at the end of all automatic outputs ( the very end of the
gcode)
Pause G-Code:
This gcode will be inserted when the printer is paused
Resume G-Code:
This gcode will be inserted when the printer is resumed
Cancel G-Code:
This gcode will be inserted when the print is canceled.
Extruder 1
Nozzle Diameter:
This is the diameter of your extruder nozzle in millimeters. R1 comes standard with a
.4mm nozzle. It is important to keep this setting unless you change the nozzle to
something different.
Retraction Length:
The amount that the filament will be reverse extruded after each non-print move.
Prevents ooze and stringing.
Change Tool:
The amount that the filament will be reversed before changing to a new tool
Z Lift: