User Manual

ManualsBrandsROBO 3D Manuals3D PrintersR1 Plus 10x9x8-Inch ABS/PLA 3D Printer, White (A1-0002-000)

Table Of Contents

37

(6.6)

• Straighten out the end of the filament so that it can easily be inserted into the extruder.

• Pull back the thumb latch on the back of your extruder, this will create an opening for

you to load your filament into.

• Insert the filament into the extruder all the way down. (It should go in about 2 inches)

• Release latch.

(6.7)

• Spin gear on side of extruder to make sure that filament is loaded correctly (only if

Extruder tip is hot!)