Use and Care Guide

46 47
•
If the E3 (“No wire signal”) message is displayed, check
that the Power Supply, extension cable and Base Station
wires are all connected properly. Check for possible
Perimeter Wire cuts.
•
If the UO51 (“Reposition Base Station”) message is
displayed, check that the Base Station is aligned with the
Perimeter Wire. Move any obstacles preventing entry
into the Base Station.
• Be careful not to damage irrigation pipes when
hammering down the stakes.
Insert the remaining two stakes into
the Base Station. Press OK.
The mower will drive to the Base
Station and enter it.
Next, it will drive out and wait in
front of the Base Station and display
U002 (“Peg Base”).