Use and Care Guide

58
59
Troubleshooting
Message
Displayed
Probable
Cause / Event
Corrective
Action
Cross
Outside
The Perimeter Wire is too
close to the edge.
Move the wire towards the inner side of
the lawn.
The lawn slope near the
edge is too big and causes
the mower to slip outside.
Do not include areas with very steep
slopes.
The lawn’s edge is too
bumpy.
Fill holes and pits along the edge till
level with the ground.
Stuck
In Place
The mower got stuck in
place. It cannot continue
driving.
Check the ground for holes or
indentations. Fill it with some earth.
Check if the Perimeter Wire is not
too close to the edge. Move the wire
towards the inner side of the lawn.
Check Mow
Height
Mowing system is in
overload due to very tall
grass or an obstacle that is
stuck or wrapped around
the blades.
Switch off the Safety Switch and inspect
the blades. Remove any foreign object
or excessive clogging inside the mowing
deck.
Raise the mowing height and switch the
TurboMode on.
Check
Power
There is a temporary power
cut.
Confirm that the Power Supply unit is
plugged in into mains.
The Power Supply unit is
not plugged in properly.
Confirm the Power Supply is plugged in.
There is no charging
source detected.
Clean the charging contacts on
the Base Station and verify proper
connection of the Base Station to the
Power Supply unit.
No Wire
Signal
/ Waiting
for Signal
Power Supply unit is
unplugged or there is a
temporary power cut.
Make sure the Base Station is
connected to the mains supply.
Signal generator may need
to be restarted.
Disconnect the Power Supply from the
mains supply and reconnect after 10
seconds.
The Perimeter Wire is not
connected to the Base
Station.
Check the connection of the Perimeter
Wire to the Base Station.
The Perimeter Wire is cut. Check for cuts in the Perimeter Wire.