Operation Manual
Chapter 6-1
Charging
Chapter 6 Charging
Proper charging of the Power Pack is of utmost importance!
Failure to follow the charging guidelines will result in poor performance
and a short Power Pack life.
Shock, injury, electrocution hazard! Robomow Power Supply is
designed for use in dry indoor locations only.
Never use the Power Supply or charge the Robomow in areas
where extreme dampness or wet contact is likely.
Never use a Power Supply when the leads are damaged.
Use only the recommended Power Supply for your Robomow.
c Important c The power supply is suitable for INDOOR use only. It is
required to place the power supply in a sheltered, dry location. It should
be well ventilated and NOT exposed to any direct sunlight or to rain.
Do NOT pack the Power Supply inside a plastic bag, as it will over-heat.
Robomow will be automatically recharged at its Base Station at
the end of all mowing sessions. It is best for the Power Pack to remain
plugged in at all times of non-use, throughout the mowing season.
There is absolutely NO need for concern: no over-charging, no over-
heating and no damaging the Power Pack.
After completion of all daily cutting sessions it is very important
to bring Robomow to its storage area and plug it into the charger. This
should be done as soon as possible, preferably within 6 hours from the
time it stopped.
Charging time is approximately 20 hours, depending on conditions.
6.1 Charging at the Base Station
The Base Station is the primary Charging Station when Robomow is
docking
P When the Power Pack is being charged at the Base Station one of
the following screens is displayed:
) If Robomow is docked and a Weekly Program is set:
) If Robomow is docked and a Weekly Program is NOT set.
Or: if Auto Depart is turned off:
Indoor Use Only