Operation Manual

29
Message
Displayed
Probable Cause/Event Corrective/User Action
Keys locked - Child lock feature has been activated
- Press the Up
 arrow key and then
press the ‘STOP’ button.
Child lock can be deactivated under the
‘Settings’ menu.
Low temperature
waiting…
- Robomow is charged and the ambience
temperature is out of range (below 32ºF /
0ºC);
- Do not do anything, the charging is
stopped and Robomow is waiting for
temperature to change back to the
allowed range; if temperature stays out
of the range for more than 12 hours, the
message is changed to ‘Low temp.
Press GO’.
Mow overheat
cooling, wait…
- The mowing motor has been working under
a severe load for too long of a time.
- There is no need to do anything –
Robomow will renew automatically the
operation, as the mowing motor will
cool down.
No wire signal
- Perimeter Switch is not turned on or not
connected to the zone intended to mow.
- The perimeter wire is not connected to the
Perimeter Switch
- The perimeter wire is cut
- Make sure the Perimeter Switch is
connected to the mains supply
- Disconnect the power supply from the
mains power and reconnect after 10
seconds.
- Check the Perimeter Switch is
connected to the correct zone and is
turned on.
- Check the connection of the perimeter
wire to the Perimeter Switch.
- Check for cut in the perimeter wire.
Rain detected
GO to ignore
- Robomow detects rain upon GO pressing
(received when pressing the GO button)
- Do not operate Robomow in rainy
weather and wet grass; If you choose to
override, press the ‘GO’ button; The
overriding is valid for the current
operation only
Rain detected
Press GO
- Robomow has skipped the last depart due to
rain detection
- It is not recommended to cut wet or
damp grass, but if you choose to
override the rain sensor, change the
setting of the ‘Rain sensor’ to ‘off’ under
the ‘Settings’ menu.
Rain sensor
disconnected
- Disconnection in the rain sensor wires.
- Press ‘GO’ to confirm the message and
call service for repair.
Ready
keep charging
- The battery is fully charged
- Keep the charger (power supply)
connected and operating
Recharge battery
- The maximum operating time has been
reached
- Connect the charger to the mower
Remove fuse
before lifting
- Robomow was lifted while the battery fuse is
connected.
- Remove the fuse before lifting
Robomow.
Remove fuse then
check blade
- Some obstacle is stuck or wrapped around
the blade.
- Something is preventing a blade from
rotating freely. Severe grass accumulation
under the mowing deck; rope or similar
object wrapped around mowing blade.
- Object jammed under mower preventing
blade from rotating.
- CAUTION – Remove battery fuse
before lifting the mower.
- Inspect blades for foreign material or
debris preventing rotation.
- Clean out accumulated grass clippings
using a wooden stick.
Replace blade
every 200 hours
- An automatic reminder to replace the blade
is displayed every 200 hours
- Replace the blades and restart the
counter of the blades replacement
reminder by choosing the ‘Blades
replaced – Clear reminder’ option
under the ‘Settings’ menu