Operation Manual

45
Message
Displayed
Probable Cause/Event Corrective/User Action
CAUTION – Remove battery fuse before
lifting the mower
- The Robomow has driven onto an
obstacle, raising the front end. Remove
or exclude this object from the mowing
area.
- The Robomow is being used on a slope
too steep for safe mowing. Exclude this
from the mowing area.
- High grass is preventing the front wheel
from fully riding on the ground. Raise
the cutting height.
Frnt wheel prob
- The Front Wheel has left the ground for
more than 8 – 10 seconds.
- The ground contains large holes or
indentions where the front wheel can
drop into when passing across. Fill
these areas with dirt and level off.
High temperature
waiting…
- Robomow is charged through the Base
Station and the ambience temperature is out
of range (above 158ºF / 70ºC);
- Do not do anything, the charging is
stopped and Robomow is waiting for
temperature to change back to the
allowed range; if temperature stays out
of the range for more than 12 hours, the
message is changed to
‘High temp.
Press GO
’.
Insert fuse
for charging
- Robomow is connected to charging without a
battery fuse
- Disconnect Robomow from charging,
insert the battery fuse and reconnect to
charging.
Keep charging
if not used
- Message is displayed every time the power
supply is disconnected.
- Displayed when the mower isn’t in operation
and not connected to the charging for a long
time.
- Press any key to change the display
back.
- Send the mower back to the Base
Station for charging / connect the power
supply or continue in operation.
Key pressed
- One of the operating panel buttons is
constantly pressed.
- Press GO’ to confirm the message and
to continue in operation. The message
is displayed to inform the user about
the problem, but will not prevent the
operation.
Keys locked - Child lock feature has been activated
- Press the Up
arrow key and then
press the
‘STOP’ button.
Child lock can be deactivated under the
Settings’ menu.
- Mower is searching for the Base Station but
the battery voltage is too low to continue the
searching process.
- Drive the mower manually using the
remote control or carry it by hand for
charging in the Base Station.
Low battery
- Robomow has skipped the last start time due
to low battery voltage
- Confirm there is enough time between
the two adjacent departures so the
battery can be charged prior the
scheduled operation (min 16 hours
between operations)
Low temperature
waiting…
- Robomow is charged through the Base
Station and the ambience temperature is out
of range (below 32ºF / 0ºC);
- Do not do anything, the charging is
stopped and Robomow is waiting for
temperature to change back to the
allowed range; if temperature stays out
of the range for more than 12 hours, the
message is changed to ‘
Low temp.
Press GO’
.
Mow overheat
cooling, wait…
- The mowing motor has been working under
a severe load for too long of a time.
- There is no need to do anything –
Robomow will renew automatically the
operation, as the mowing motor will
cool down.