Operation Manual

No. of
beeps
ON-OFF
indication
Meaning Corrective action
• Blinking red Mower crossed
outside / mower
is stuck in place /
lift event detected/
wrong wire connection
• Check that the Perimeter Wire is
not too close to the edge or not on
a sloped area.
• Move the mower inside the lawn or
away from this particular location
and renew the operation.
• Check the ground ditches. Fill with
dirt and level off.
• Swap wire connections at the base
station head
• • Blinking red Check the blade /
mow motor overheat
• Remove the Disabling Device and
inspect the blade for foreign mate-
rial or debris preventing rotation.
• Increase cutting height.
• • • Blinking red No wire signal /
waiting for signal /
wire is cut
• Confirm power supply is plugged
into the power outlet.
• Check power supply and perim-
ter wire connection to the Base
Station.
• Check the indication on the Base
Station. If the wire is cut, repair is
with the provided wire conenctors.
• • • • Blinking red Check drive wheels /
drive motor overheat
• Check the drive wheels and
remove grass or other objects.
49
Troubleshooting
Simple troubleshooting steps
In case of a fault, the Robomow On/Off indication will light up in red. Press any
button to check for an optional sound indication for the fault. The table below will
guide you to the corresponding action to take.