Operation Manual

20 cm/8”
20
Pull out the wire marked
A from the Perimeter
Wire spool; leave a tail of
approx. 20 cm / 8”; once a
tail is made, put the first
peg into the ground to
secure this wire end.
Drive pegs at two
additional locations: at
RoboRuler distance I
along the edge from the
first peg, and at RoboRuler
distance III from the edge
as shown in the picture.
2
3
Measure RoboRuler distance
III from the corner, where
you intend to install the
Base Station and mark
this point on the ground.
1