Operation Manual

31
GO!
Your Robomow is ready!
• Place Robomow in the center of your lawn
• Press GO for 2 seconds to switch it on
• Now press the STOP /
once to send Robomow to the Base Station.
• Robomow will start driving* towards the edge of the lawn to locate
the Perimeter Wire. Once on it, Robomow will follow the wire to
reach the Base Station and park there for charging.
(*) If Robomow doesn’t start driving, but plays a long beep and blinks with
ON-OFF indication in red, you should swap the Perimeter Wire connection
at the Base Station Head. For additional troubleshooting information please
refer to “Troubleshooting” section in the “Quick reference” part.
2 sec