Operation Manual

EN
16
26cm (10in) width - the short
distance of the RoboRuler
RoboRuler
Wire pegs
Lawn
Lawn
Base Station
40cm (16in) width - the long
distance of the RoboRuler
26cm (10in) width - the short
distance of the RoboRuler
RoboRuler
Wire pegs
Lawn
Lawn
Base Station
40cm (16in) width - the long
distance of the RoboRuler
 The setup of the entering to the narrow pass
leads to the Base Station should include
triangles to reduce the chance that
Robomow will enter towards the station while
mowing the inner area (scanning); to perform
the triangle setup refer to Figure 1.9.
 The distance between the wires lead to the Base Station and back to the lawn is 26cm (10 in).
 The Base Station should be placed on the right wire of the narrow pass (when standing inside the
lawn).
Important: as the two wires are very close and affect the wire sensors readings, the Base Station
should not be aligned with the central lines marked on the Base Station; it should be placed with a
shift of 10-20cm (4-8 inches) to the right.
 It is reccomneded to placed the Base Station at least 25cm (10 inches) before the end of the
external pass to allow the mower smooth entrance to the Base Station.
26cm /10“
Triangle as done in
narrow pass type B
(refer to Figure 1.7)
R
e
c
o
m
m
e
n
d
e
d
(
u
p
t
o
3
m
/
1
0
f
t
)
Base Station is placed with a right
shift of 10-20cm (4-8“)
(not aligned with the wire)
Recommended to continue
the wire for at least 25cm
(10”) after the Base Station
26cm /10“
Triangle as done in
narrow pass type B
(refer to Figure 1.7)
R
e
c
o
m
m
e
n
d
e
d
(
u
p
t
o
3
m
/
1
0
f
t
)
Base Station is placed with a right
shift of 10-20cm (4-8“)
(not aligned with the wire)
Recommended to continue
the wire for at least 25cm
(10”) after the Base Station
Figure 1.9
Setting the triangles
for external setup of
Base Station
Figure 1.10
External setup of
Base Station