Operation Manual

EN

20
 Align the Base Station on the Perimeter Wire, so the wire is aligned with the two central lines
marked at the front and rear side of the Base Station, as shown in Figure 1.22. Do not fasten the
Base Station yet, as you will want to check its final position first.
 Connect the power supply to a regular household receptacle 230 Volts AC.
 A small flashing green light in the Base Station cover indicates the system is on and functioning
properly. Continuous beeps indicate a disconnected/broken perimeter wire. Discontinuous beeps
indicate poor splicing of perimeter wires or perimeter wire, which is too long (the max allowed in
one loop is 500 meters).
1.5 Robomow Preparation and Settings
1.5.1 Setting the Cutting Height
 Lift the Bumper Cover from the front side of the Robomow (figure 1.24).
 To change the cutting height, rotate the cutting height adjustment knob, as shown in figure 1.25.
Figure 1.23 -
Base Station
Operating Panel
Flashing light
indicates the s
y
stem
Discontinuous beeps indicate
poor splicing of perimeter wires
or
p
erimeter wire
,
which is too
Continuous beeps indicate a
disconnected/broken wire
Figure 1.22 -
Base Station alignment
Figure 1.24 -
Lifting the Bumper Cover
Cutting height
adjustment
knob
Mowing
motor
Carrying
handle
Winter Charger
location
Fuse locationControl Panel
Figure 1.25 -
Tuscania 500 General
Vi