Operation Manual

EN
21
STOP
GO
STOP
GO
Operating Lamp
UP
arrow
DOWN
arrow
Rain
sensor
LCD display
window
GO / START
button
Main Switch
button
STOP button
1.5.2 Inserting Batteries Fuse
 Your Robomow is shipped with the batteries fuse
removed and it will not operate without it. The fuse is
assembled inside its rubber cover, located under the
Bumper Cover (Figure 1.26).
 Lift the Bumper Cover, remove the partition and insert
the fuse. The fuse can be inserted in either direction.
See figure 1.26
 Robomow will now power up (wake up). The Batteries
are charged at the factory and have plenty of power to
perform the initial setup and test run. However, after the
initial set-up process is completed the batteries need to
be charged 16 hours in the Base Station before the first
operation.
1.5.3 Robomow Settings
 Control Panel
 On the top of the rear side of Robomow there is a control panel. The control panel consists of a
display, keypad and operating lamp (figure 1.27).
 The ‘GO’ button is used as a means to select or confirm different menu options or settings;
 ‘Up

/ Down

’ arrow keys will allow you to scroll through the menu items;
 The ‘STOP’ button has two different functions: when pressing during automatic operation it will
stop Robomow and blade operation immediately and when pressing at any time during the
menu selection process it will bring you one step back in the menu.
 ‘Main Switch’ button is used to switch off the Robomow. It is required to switch off the
Robomow when carrying it between zones.
IMPORTANT INFORMATION!
Follow the instructions on the LCD display - Robomow will
friendly instruct you, step by step, how to complete the setup
Figure 1.26 -
Inserting batteries fuse
Figure 1.27
Control Panel