Operation Manual

EN
30
Figure 2.6
Setting the
‘Work time’
Max
Confirm
1:30
Confirm
Work time
Press GO
Scroll to select different
operating time.
Press ‘GO’ to confirm
Press ‘GO’ to set ‘Work time’
Max
Confirm
Max
Confirm
Max
Confirm
1:30
Confirm
1:30
Confirm
1:30
Confirm
Work time
Press GO
Work time
Press GO
Work time
Press GO
Scroll to select different
operating time.
Press ‘GO’ to confirm
Press ‘GO’ to set ‘Work time’
The following characters may appear under each of the active days:
Character Meaning
+ Active day
B
Skipped due to low battery voltage;
(Robomow did not depart from the Base Station at the scheduled time due to
low battery voltage)
b
Docked before time due to low battery voltage;
(Robomow did not complete the operation and drove back to the Base Station
due to low battery voltage – relevant only when
‘Work time’ different from
‘Max’ is set)
d
Robomow did not return to the Base Station because of Drive over current
('Start elsewhere') or 'Drive problem'; Robomow returned to the Base Station
before time due to drive overheat.
M
Skipped due to mow over current detected in the Base Station before
Robomow has started the operation.
m
Robomow returned to the Base Station before time due to mow problem (over
current or over heat)
O
Skipped because the mower was out of the Base Station at the scheduled start
time
P Skipped due to power problem (there is no charging voltage at departure time)
R
Skipped due to rain;
(Robomow did not depart from the Base Station at the scheduled time due to
rain detection)
r
Docked before time due to rain;
(Robomow did not complete the operation and drove back to the Base Station
due to rain detection during the operation)
S
Skipped due to signal problem (it may happened because of problem with wire
sensors, cut perimeter wire, poor splicing of perimeter wire or perimeter wire
which was too long).
s Robomow returned to the base because of no signal for more than 1 hr
U
Skipped due to user choice/interference (usually when the ‘
Program’ set to
‘off’)
u
Robomow did not return automatically to the Base Station because of user
interference
2.1.2 Work time
 Allows the user the option of setting the operating time from 15 minutes up to 2 hours and
‘
MAX’ which is generally 2.5 to 3.5 hours, depending on grass type and condition (figure 2.6).
 This menu is used when operating the mower in Manual Start from the Base Station, as when
the mower departes automatic from the Base Station, the
‘Work time’ it used is as defined in
the weekly program.