Directions for using Pingpong ©ROBO RISEN
Safety information 1. Pingpong is designed for over 6, educational use, and makers. Keep the unit away from small children. Do not use units unintended ways. 2. Pingpong can cause failure or trouble by the wrong power supply, malfunction from hardware or software of computers, users' carelessness, unsuitable installations or environments, or other various causes. 3. Pingpong is designed for indoor uses.
Specifications Power DC 5V, 1A Battery Lithium-ion battery, 3.7V, 300mAh Connectivity Sensors and others Bluetooth LE 5.0 IoT Multiprotocol Infrared Proximity sensor 6DOF IMU, Accelerometer and Gyroscope Infrared Origin Detector LED: Red for power, Green for Bluetooth, and LED indicator Electromagnetic Buzzer Motor Digital I/O port CPU Stepper 100:1, 180DPS/1000SPS 4-pin External input port: Servo, IR Remote connector ARM Cortex M4 (32-bit, compatible with BLE 5.
Getting to know pingpong LED indicator proximity sensor
Getting to know pingpong stepper external input (4pin) magnetic charger
Control button To turn on, press the yellow button shortly. To turn off, press the button longer. To connect pingpong to other devices, press the button one more time.
LED indicator 1. If your pingpong did not connected to others, the LED indicator slowly changes its colors. 2. If your pingpongs are paired, the master’s indicator shows red, and slaves shows green, blue, sky-blue, pink, yellow, purple in order. 3. Until the master pairs to slaves, the master’s indicator flickers in red. 4. If any paired pingpong loses its connection, the master flickers again. 5. If you made a particular group, your pingpongs shows the color according to your group code.
LED indicator
Power management When the unit won’t be used for a long time, press the button long to turn off. Full battery charge is needed before using. Recharge your pingpong with rated output adaptor (3A), do not recharge it through USB port in laptop or desktop computers. If you recharge several pingpongs with one charging cable, it takes one and a half hours. (It takes same time 1~12 units by one cable.) If the cable recharges more units, it takes more time.
Warning Overheat warning: When the motor is overheated, the LED indicator flickers in pink and the motor stops. Then you need to power off the pingpong, and cool down it more than 10 minutes. The overheat warning occurs if the pingpong raises other units and maintains it, or it worked hard for a long time LED indicator shows pink, and the motor is out Low battery warning: When the battery is too low, the LED indicator flickers in red 5 times and powered off.