Roborock Xiaowa Robotic Vacuum Cleaner Manual Please read this manual carefully before using the product and store it properly
Safety Information Restrictions This product is designed for indoor floor cleaning only, do not use it outdoors (such as on an open-ended terrace), on any surface other than the ground (such as a sofa), or in any commercial or industrial environment Do not use this product on elevated surfaces without barriers such as the floor of a loft, an open-ended terrace, or on top of furniture Do not use the product when the ambient temperature is higher than 40℃, lower than 4℃, or if there are liquids or tacky subst
Safety Information This product can be used by children aged age 8 years and above and persons with reduced physical, sensory or mental capabilities or a lack of experience and knowledge once they have been given supervision or instruction concerning the safe use of the product and understand the hazards involved. Children should not play with the appliance.
Safety Information The product must be switched off and the plug must be removed from socketoutlet before cleaning or maintaining the appliance Do not use wet cloth or liquids for cleaning the product Do not use the mopping module on carpets Use the product according to the manual.
Safety Information If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard Make sure the product is powered off before shipment. Use of the original packaging is advised If to be left unused for a long period of time, fully charge the product and switch it off before storing it in a cool, dry place.
Introduction Main unit Spot cleaning Press to start spot cleaning Clean/ON&OFF Press to start cleaning Press and hold to power on or off POWER light White: battery capacity ≥ 30% Red: battery capacity < 30% Slow flashing: Charging or starting up Flashing red: Error Recharge Press to return to charging dock Note: press any button to pause cleaning, recharging or spot cleaning Reset WIFI Press and hold and Cover latch for 3 seconds
5
Introduction Dust bin Main unit Dustbin lid Dustbin latch WIFI indicator Slow blinking: Waiting to connect Fast blinking: Connecting Strainer Stable: WIFI is connected Air vent Speaker Accessories Charging dock Main brush cleaning tool 6 Power cable
Introduction Main unit and sensors Charging dock Charging dock indicator Signal transmission area Infrared deceleration sensor Power connector Charging point Charging point Cliff Sensor Omni-directional Omni-directional wheel charging dock sensor Charging contact points Bumper Side brush Main wheels Main brush Main brush cover latch 7
Installation 3 Powering on and charging 1 Connect the power cable and use a cable tie to clear excess wiring Press and hold the button to power on, wait until the power light sops flashing, then dock the main unit to the charging dock to charge The product is equipped with a high-performance lithiumion rechargeable battery. Keep the product charged for maximum battery performance. 2 Place the charging dock on a level surface, flat against a wall, plugged into a power outlet.
Installation The product is compatible with the Mi Home smarthome platform and can be controlled in the Mi Home app. It supports the MIUI system and can be linked with other Mi Home intelligent products. Quick Setup 1 Download App Search "Mi Home" in App store/Google play or scan the QR code below to download and install the Mi Home app. 2 Add Device Go to the "My Device" page of the Mi Home app and tap "+" on the top right corner.
Installation Routine Maintenance WIFI indicator Main brush *Clean weekly Slow blinking: Waiting for connection 1. Turn over the main unit and press the latch to remove the main brush cover Fast blinging: Connecting Stable: WIFI connected 2. Lift out the main brush and clean its bearings 3. Use supplied main brush cleaning tool to cut any entangled hair 4.
Routine Maintenance Dust bin and filter * Clean weekly 1. Open the top cover of the product and press the dust bin latch then lift and remove the dust bin 3. Turn the dust bin over and pour out the dust Note: To avoid filter blockage, tap the dustbin lightly on the edge of the bin 2.
Routine Maintenance Battery Do not wash the filter with water, this may cause filter blockages The product is equipped with a high-performance lithium-ion rechargeable battery. Keep the product charged for maximum battery performance. Note: Replacing the filter every 3-months is recommended for maximum cleaning effectiveness Note: If to be left unused for a long period of time, fully charge the product and switch it off before storing it in a cool, dry place.
Routine Maintenance Sensors * Clean monthly Charging dock * Clean monthly Use soft dry cloth to wipe clean each sensor: Use soft dry cloth to clean the charging contacts on the charging dock 1. Four cliff sensors on the bottom 2. Infra-red deceleration sensor in the front 3. Charging contacts on the bottom Firmware update You can use the Mi Home app to for firmware updates. Connect the main unit to the dock charger and ensure that battery capacity is above 20% before updating.
Basic parameters Main unit Name Charging dock Specifica tions C1*****( * can be 0 to 9, A to Z, a to Model z, "-", "_", "\", "/" or blank, for marketing purpose.) Outline Dimensions 353x350x90.5mm Battery 14.4V/2600mAh lithium battery Weight About 3.0kg Wireless connection WIFI Smart Connect Voltage rating 14.4VDC Power rating 50W 14 Name Specs Model CDZ03RR or CDZ04RR Outline Dimension 151x130x98mm Power rating 42W Input rating 100-240VAC Output rating 20VDC 1.
Xiaowa Model Comparison Xiaowa Lite Xiaowa Xiaowa Plus Model( can be 0 to 9, A to Z, * to z, "-", "_", "\", "/" or blank, for marketing purpose.) Xiaowa C1 ***** Xiaowa E2 ***** Xiaowa E3 ***** Cleaning method Wet mopping function No mopping Sweeping + mopping Sweeping + mopping Navigation method Adaptive random navigation Inertial navigation route planning Inertial navigation route planning Automatic recharge √ √ √ Cleaning capacity Obstacle clearance height 2.0cm 2.0cm 2.
Troubleshooting If an error occurs, the power indicator will flash red and a voice prompt will sound. Use the table below to resolve these errors Fault display Solution The bumper is stuck. Lightly tap it several times to dislodge any trapped material. If nothing is found, move the main unit to a new location and restart Error 2: Please inspect the bumper Error 3: Please move the machine to a new location and start it A wheel is stuck.
16
Troubleshooting Error 12: Battery low Error 13: Charging error Battery low, charge it before use; Use a dry cloth to wipe the charging contact points on the main unit and the charging dock Error 14: Battery error Battery temperature is too high or too low battery. Wait until the battery temperature returns to normal before use Error 17: Side brush exception, please reset the system The side brush module has malfunctioned.
EU Declaration of Conformity Hereby we: Name of manufacturer Beijing Roborock Technology Co.,Ltd. Address Floor6,Suite6016,6017,6018,BuildingC,Kangjian Baosheng Plaza,� No.8 Heiquan Road,Haidian District, Beijing,P.R.CHINA declare that this DoC is issued under our sole responsibility and that the products: Product description Robotic Vacuum Cleaner and Accessories Type(model) designation(s) C1*****( * can be 0 to 9, A to Z, a to z, "-", "_", "\", "/" or blank, for marketing purpose.
EU Declaration of Conformity RED Directive 2014/53/EU Article 3.1 b): EMC 1. Draft EN 301 489-1 V2.2.0 2. Draft EN 301 489-17 V3.2.0 3. EN 55014-1:2017 4. EN 55014-2: 2015 5. EN 61000-3-2: 2014 6. EN 61000-3-3: 2013 1.Electromagnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements; Harmonized Standard covering the essential requirements of article 3.1(b) of Directive 2014/53/EU and the essential requirements of article 6 of Directive 2014/30/EU 2.
19
EU Declaration of Conformity Low Voltage Directive 2014/35/EU 1. EN 60335-1:2012 + A11:2014 2. EN 60335-2-29:2004 + A2:2009 3. EN 62233:2008 1.Household and similar electrical appliances-Safety-Part 1: General requirements 2.Household and similar electrical appliances-Safety-Part 2-29: Particular requirements for battery chargers 3.Measurement methods for electromagnetic fields of household appliance and similar apparatus with regard to human exposure 1.
20
WEEE Information Correct Disposal of this product . This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased.
Warranty Information The seller provides warranty in accordance with the legislation of the customer's own country of residence, with a minimum of 1 year,starting from the date on which the appliance is sold to the end user. The warranty only covers defects in material or workmanship. The repairs under warranty may only be carried out by an authorized service centre. When making a claim under the warranty, the original bill of purchase (with purchase date) must be submitted.
Robotic Vacuum Cleaner Manufacturer: Beijing Roborock Technology Co., Ltd. Product Model: C1***** (* can be 0 to 9, A to Z, a to z, "-", "_", "\", "/" or blank, for marketing purpose.) Address of Manufacturer: Floor 6, Suite 6016, 6017, 6018, Building C, Kangjian Baosheng Plaza, No. 8 Heiquan Road, Haidian District, Beijing, P.R. CHINA For more product information, please visit our website: www.roborock.