Use and Care Manual

10
C6
Charging and Self-Cleaning
1. Lock the cleaning head, and place the
vacuum cleaner onto the charging dock.
The voice alert “Charging” indicates that the
vacuum cleaner is charging.
2. Press the Self-Clean button to start standard
self-cleaning. Press and hold the clean
button for 2 seconds to switch to DEEP self-
cleaning mode.
3. After self-cleaning finishes, empty the dirty
tank to prevent odor.
Notes:
 The product is equipped with a built-in high-performance
lithium-ion rechargeable battery pack. To maintain battery
performance, keep the product charged for normal use.
 Always place the vacuum cleaner on the charging dock after
use to prevent water stains.
Drying
Voice Alert Settings
Drying starts automatically after self-cleaning
is completed. To manually start or stop drying,
press the power button on the docked vacuum
cleaner.
Connect to the app to adjust the volume of
voice alerts.
Product Maintenance
Cleaning the Body
To maintain optimal performance of the
product, refer to the following table for routine
maintenance.
If this product is left unused for a prolonged
period of time, fully charge it and unplug it
before storing it in a cool and dry place. Do not
place the product in humid locations or under
direct sunlight. Charge it at least once every 3
months to avoid overdischarge.
Wipe and clean the body with a soft and dry
cloth. Before cleaning, unplug the power
supply and keep the vacuum cleaner off.
Routine
Maintenance
D
Parts
Maintenance
Frequency
Replacement
Frequency
Roller 2–4 weeks 6–12 months
Filter 1 month 6–12 months
Cleaning head
and dirty water
pipe
1 month N/A
Dirty tank 1 month N/A
Dirty water level
sensor
1 month N/A
Charging dock
tray
As needed N/A
Charging
contact
1 month N/A
Take out the dirty tank, pull out the
cover, and open the water level sensors.
Clean the parts with the provided
maintenance brush, rinse them with
cold water, and then snap the water
level sensors back in place.
1. Remove the vacuum cleaner from the
charging dock, switch it off.
2. Place the vacuum on a hard and flat floor
and lock the cleaning head.
Take out the filter from dirty water tank
cover and remove any trash attached
to the filter. If the filter is dirty, rinse it
with cold water and then shake off the
residual water.
Rotate the roller cover to the unlock
position, and pull the roller outward.
Allow up to 24 hours for all parts drying
and install them back in place.
D1
Cleaning the Dirty Tank and
Filter
D2
Cleaning the Roller
D1-1—
D1-2—
D2-1—
D1-3—
Notes:
 Use a second filter if necessary.
 Do not touch the filter with your hands, brushes, or sharp
objects to avoid damage to the filter.
Cut off any hair entangled on the
roller and remove any debris using the
provided maintenance brush.
D2-2—
Note: Use the maintenance brush carefully to avoid injury.