User Manual

Basic Operation
RoboSHOOT
©
User’s Manual Page 21
Stand Alone Operation
Using the MX-15 or MX-20 (without using smartphone)
Fully automatic TTL off-camera flash is supported
without a user interface. No cables are required
unless you wish to activate the shutter from the
device (MX-20 only). Just connect the units as
indicated in ‘Getting Started’, set the camera and
flash modes, and you are ready to begin shooting.
You can do quite a lot without using a smartphone:
 Flash Enable / Disable
 Flash Exposure Lock
 Profile Selection
 Profile Bracketing*
 Sensor Activated Exposures*
 Flash Test
 Group Selection
* - MX-20 only, shutter release cable required.
Group Assignment on Slaves
The Master is always on Group A. To change a slave
to a specific group, push-and-hold the top button
fully on that slave (see page 12).