User Manual

Basic Operation
RoboSHOOT
©
User’s Manual Page 23
Enabling or Disabling Flashes quickly
Push-and-hold the side button to enable/disable
flash (see page 11). The Main LEDs will strobe when
the command is accepted and the Group LEDs will
indicate current status. To re-enable the flashes, just
repeat the push-and-hold or click the button to
clear. Turning on the camera or engaging another
device function will also re-enable all groups.
Flash Exposure Lock
Flash Exposure Lock (FEL) is engaged by fully clicking
the top button (see page 11). If an exposure was
previously taken, the reference power may be
already available for use. Otherwise, the next
exposure will be used for the reference. If a camera
mode change occurs (power, operating mode,
aperture, or ISO), the reference will be cleared and
again the next exposure will set the exposure
reference.
Exit FEL by clicking the side button or turning the
camera off/on.