User Manual

Basic Operation
RoboSHOOT
+
©
User Manual Page 28
Multi-Master Mode
Multi-Master mode allows you to share flashes with
additional cameras. Each MX unit configured in
multi-master mode will take control of shared RX
units when its camera is turned on. This is all done
automatically. The flash Group settings are retained
for each MX independently, so, the flashes will
respond to each camera as if they are not shared. In
this way, your settings can be customized according
to the use of the camera. For example, a flash
pointed at a camera can be disabled for that camera
and enabled for another – set automatically
according to which camera is in-use.
To use Multi-Master mode:
 Set each MX unit to Multi-Master mode
(see Device Admin page for information)
 Make sure each MX device is using the
same radio channel and the same App
settings
It is recommended to use this mode ONLY when the
capability is needed. Otherwise, you may start
sharing your flashes with others unintentionally!
Flashes in use by Multi-Master MX units will ignore
MX units not in this mode, so unintentional
sharing can only happen when others are using
this mode.