User Manual

App Control
RoboSHOOT
+
©
User Manual Page 41
TTL requested power can be overridden by adjusting
the Master knob. This always affects overall flash
exposure when any knobs are in TTL mode and a
ready speedlight is assigned to that group.
The left side indicators are similar to the flash ready
on your speedlight, except they indicate ready for
the entire group.
At the bottom third of the page you find controls for
Flash Enable, Overall TTL Power Offset, Flash
Exposure Lock, TTL Flash Test, Shutter Release, and
optionally Modeling Light.
Modeling Light, Profile tray and zoom controls may
not be visible. To modify, click the settings icon in
the upper right corner and select ‘group function
settings’
Zoom controls allow you to set the speedlight zoom
for each group. It can be set as a specific value or as
a multiple of the current lens/camera setting. This
gives you finer control over your subject
illumination.
Modeling light briefly activates this function on your
flash, if compatible.
The profile tray allows you to select and edit profiles,
which may be used individually or for bracketing.
MX-20
+