User Manual

Device Admin
RoboSHOOT
+
©
User Manual Page 47
Special Power-up Button Functions
Several button combinations can be used at power
up to select various functions on the MX unit. These
are intended as one-time or seldom used
configurations. You may repeat the operation if it
was not successful (for example if you accidentally
moved while holding buttons).
MX-20
+
Firmware Update: At power up hold Side +
½ Top buttons until LEDs complete cycling one-by-
one.
To initiate a firmware upload on an MX-20
+
device:
1. Remove MX-20
+
from the camera and turn it off.
2. Press-and-hold the side button with the top
button held ½ way and turn the unit on.
3. Once the LED cycle through all LEDs is complete
release both buttons. If successful, the main
LEDs will indicate Yellow with rapid Red flashing
followed by ALL Group LEDs Blink Green-Red-
Green. Click side button if this pattern does not
stop. Then, the main Yellow will indicate a
double blink pattern.
4. Start the App and connect to the MX-20
+
.
5. The App will start in Updater mode, Check for an
update and install it if available.