User Manual

Device Admin
RoboSHOOT
+
©
User Manual Page 48
You can cancel an upload if it hasn’t yet begun by
restarting the MX device while pressing-and-holding
the side button. If successful, update will halt and
normal operation resume the next time you restart.
RX unit Update: RX devices are uploaded
automatically when the Master (MX) device gets
new firmware and you sync the RX devices with the
MX device. To do this, place the MX and RX units
near each other, turn on all RX units then turn on the
MX unit. The RX update takes about 3 minutes.
MX-15
+
Firmware Update: Since the MX-15
+
does
not support the App, updates are not available using
it. Instead the MX-15
+
supports unit-to-unit updates.
If you have access to an MX-20
+
, you can use it to
update your MX-15
+
. To do this, place your MX-15
+
in update mode as described above in in steps 1-3.
Once the MX-15
+
in in update mode turn on the MX-
20+ and place it close to the MX-15
+
. After about five
minutes the update will be complete either unit can
be used to update your RX units.
See www.sereneautomation.com for further details.
Note, firmware update resets all settings to default.
If you’ve changed MX-20
+
settings via the App, prior
settings can be restored by forcing consistency
(p37).