User Manual

Device Admin
RoboSHOOT
+
©
User Manual Page 51
All MX units must have Multi-Master mode active if
the wish to participate in RX sharing. When this
mode is active, turning on a camera will cause the
flashes to associate with it and disassociate with any
other camera. Any profiles and settings are taken
from the newly associated camera/MX unit. Thus,
you are able to set up the flashes according to the
needs of that camera without affecting a different
camera’s settings. So, for example, you might have
one group enabled on one camera and a different
group enabled on another camera. Likewise for
Power, Zoom, and TTL offset settings and any other
modes.
Note, while operating in Multi-Master mode, if
someone else is also using Multi-Master mode in the
same area they could take control of your flashes. If
this occurs, simply change all your MX units to a
different channel (they must be all on the same
channel), restart your RX-units and turn on a camera.
This will set all RX units to the new channel and
avoid any possibility of interference. App Settings,
including channel number can be sent to each MX
unit by forcing consistency (p37). To connect the
App to an MX unit only one MX unit may be on at a
time. The Multi-master mode setting is maintained
even if power is switch off or batteries are changed
and is unaffected by App Settings.