User Manual

Device Admin
RoboSHOOT
+
©
User Manual Page 52
Multi-Angle Photography: The MX-20
+
/RX-20
supports Multi-Angle photography by taking
simultaneous exposures from different locations. To
enable this mode the RX-20 X-sync port must be
reconfigured as a shutter release port. This is done
on each RX unit individually and you can have
multiple RX-20s configured either way as you wish.
To Toggle the RX-20 port between X-sync and
shutter release, turn off the RX-20 and fully hold the
Top button while turning it back on. Continue to
hold for several seconds after the main yellow LED is
steadily on. Once you see the main Red LED blink
you can release. If set to X-sync the Red LED blinks
3x slowly or is set to Shutter Release the Red LED
blinks 5x quickly. This same 5x blink will occur every
time to turn on the unit to indicate it is set to Shutter
Release. This mode will remain active until you
toggle it again, restore the unit to defaults, or load
new firmware.
With Shutter Release configured and release cable
attached to the RX-20, its camera will take exposures
either by App (Expose button, Timer, Intervalometer,
or High Speed Capture) or by external trigger on the
MX-20
+
. While Flash is not supported in this mode, it
is not prevented either and may work with low
shutter speeds using 2
nd
curtain sync.