User Manual

Admin and Troubleshooting
RoboSHOOT
©
User’s Manual Page 37
System Reset
To Reset the unit to factory defaults, press-and-hold
the top button fully, the side button, and turn the
unit on. Hold these buttons for about five seconds
until the Red LEDs blink five times rapidly. The unit is
reset to factory defaults.
Firmware Upload
To initiate a firmware upload on an MX-20 device
first, remove it from the camera and turn it off:
 press-and-hold the side button with the top
button ½ way and turn the unit on.
 Once the LED cycle through all LEDs is complete
release both buttons.
 Start the App and connect to the MX-20.
 The App will start in Updater mode, Check for an
update and install it if available.
You can cancel an upload if it hasn’t yet begun by
restarting the MX device while pressing-and-holding
any button. It will then halt and resume normal
operation the next time you restart again.
RX devices are uploaded automatically when the
Master (MX) device gets new firmware and you sync
the RX devices with the MX device.
See www.sereneautomation.com for details.