Data Sheet

www.veear.eu
User Manual (1.0.8) EasyVR 3 67
Updating Firmware
The EasyVR firmware can be updated in a similar way to custom data by using the command “Update
Firmware...” from the “Help” menu. Note that you must first disconnect from the module and do the steps
required to start it in “boot-mode” (see the section Flash Update).
The specified file will be verified as an official firmware release and basic version information will be
displayed. If the firmware passes the verification step, then the “Download” button will be enabled.
Figure 13 - Interface for updating EasyVR firmware
Note: After a new firmware is downloaded to the module, the custom data already present is
erased and it must be downloaded again if necessary.