User Manual

- 14 -
Software Installation
1. If the PC is off, turn it on. Windows will find the receiver and
automatically start the usual New hardware found driver installation
routine. Insert the installation CD ROM into the drive, and follow on-
screen instructions. (Note: Windows NT will not automatically detect the
receiver, as it does not support Plug and Play.)
2. After installing the drivers, choose the Run command from the Start
menu in Windows and type D:\INSTALL (if the CD ROM is the D: drive
on your PC).
3. This will run the application installer, which will guide you in the
installation process.
4. After all the files have been installed to your hard disk, run the
WiNRADiO G303 application.
Note: If the receiver is not detected by Windows, you can simply skip the
driver installation procedure, insert the CD ROM, and run the installation
program, which will also install the drivers.
Setting up the Sound Card
This section refers to the G303i model, or the G303e model with serial
interface, only. The G303e model with the standard USB interface does
not require this set up and this entire section may be skipped.
After installing the hardware and software, you will now need to set-up the
sound card parameters. This is done both in the WiNRADiO application and
in the Windows sound card control panel – this provides the actual
connection between the receiver front-end and the PC back-end of your
radio system.
In computer terminology a sound card is a wave device. A computer may
have several such wave devices installed (for example a modem with voice
capabilities). That’s why you need to select the sound card as the desired
wave device first. Start the WiNRADiO G303 application and click on the
Setup button (located below the USB button) in the demodulator panel: