User Manual

- 37 -
Scan Settings
There are two basic actions the software can do when a signal is found:
Pause scanning or Stop scanning. If Pause is selected, then you need to
further specify the conditions under which the scanning will Resume. The
conditions to resume can be one of the following:
1. When the signal disappears (i.e. the scanning resumes immediately
when the signal disappears);
2. After a certain user-defined Delay time (i.e. no matter if the signal
disappears during this Delay Time or not, the software will always wait
for the Delay Time interval, then resume);
3. When the signal disappears during Delay time (i.e. the scanning will
resume after Delay time, or earlier if the signal disappears);
4. When there is no signal during the Delay time (i.e. the scanning will
resume if there is a no-signal gap equal to, or longer than, Delay time).
The Delay time interval can be set from 1 to 100 seconds.
The Scan rate controls the speed at which scanning occurs, by specifying
the maximum number of scanning steps per second.