User Manual

- 38 -
Note that the upper scanning speed limit may be restricted by the available
CPU resources of your computer.
When a signal is found and scanning pauses, waiting for the pre-set Delay
time to expire, the countdown timer will appear inside the [<<] or [>>]
buttons. If no Delay time was set and scanning is pausing until the signal
disappears, then the [<<] or [>>] button will flash.
Groups
The Groups setting is useful for Memory Scanning, which will be described
later: it serves to restrict Memory Scanning to particular memory groups
only.
Exclusions
Sometimes it is desirable to exclude certain frequencies from scanning. This
means that such specified frequencies should be ignored even if the signal
level on these frequencies is higher than the squelch.
The WiNRADiO G303 receiver application makes it possible for multiple
frequency ranges to be excluded. This is done using the Exclusions button.
When you press this button, you will open an Exclusions editor window,
allowing you to enter a range of frequencies to be excluded.
For these exclusions to become active, check the Enable excluding while
scanning checkbox in this window.
Frequency Range Scanning
To be able to use Frequency Range Scanning, you need to set up the
desired scanning ranges first. This is done using the Ranges button in the
Options | Scanning top-bar menu.