User Manual

- 46 -
Problem: I can hear the audio and tune the receiver, but the volume is
too low, even if I adjust the Volume control to maximum.
Solution: Engage the Audio AGC in the demodulator front panel
(typically, the Med setting is used).
G303i or G303e with serial interface option only: Also check the Input
gain in the demodulator Setup panel: it should be set as high as possible,
just below the clipping level.
Problem (G303i or G303e with serial interface option only): The
WiNRADiO application installed OK, but there is no sound coming from the
speaker.
Solution: Check if you see any noise appearing in the demodulator
spectrum scope (under the AM, AMS, etc., mode selection buttons). If there
is a flat line or only very little noise visible, check the following:
• The receiver output is connected to the sound card Line input using the
supplied cable. (If your PC sound card does not have a Line input, you
can use alternative inputs such as Microphone or Aux but the
software settings need to be changed accordingly.)
• The sound card has been set up correctly. Especially make sure that the
Recording Line input has been enabled (you will find this panel under
Options | Recording in your sound card volume control panel – click on
the speaker icon in the bottom bar to get to the volume control panel
first):