User Manual

WiNRADiO G3XX VHF/UHF Receiver
Scanner Configuration
When a signal strength level is higher than the squelch level, this indicates that
a signal has been found. You can configure the software to specify what action
you want to be taken at this point. To access this configuration facility, go to
Options | Scanning in the top bar menu.
There are two basic actions the software can do when a signal is found:
Pause scanning or Stop scanning. If Pause is selected, then you need to
further specify the conditions under which the scanning will Resume. The
conditions to resume can be one of the following:
• When the signal disappears (i.e. the scanning resumes immediately when
the signal disappears);
• After a user-defined Delay time (i.e. no matter if the signal disappears
during this Delay Time or not, the software will always wait for the Delay
Time interval, then resume scanning);
• When the signal disappears during Delay time (i.e. the scanning will not
resume if the signal returns within an interval shorter than, or equal to,
Delay Time);
• When there is no signal during the Delay time (i.e. the scanning will
resume if there is a no-signal gap equal to, or longer than, Delay time).
• The Delay time interval can be set from 1 to 100 seconds.
52