User's Manual

- 29 -
Scan Settings
There are two basic actions the software can do when a signal is found:
Pause
scanning or
Stop
scanning. If Pause is selected, then you need to
further specify the conditions under which the scanning will
Resume
. The
conditions to resume can be one of the following:
1. When the signal disappears
(i.e. the scanning resumes immediately
when the signal disappears)
;
2. After a certain user-defined
Delay time
(i.e. no matter if the signal
disappears during this Delay Time or not, the software will always wait
for the Delay Time interval, then resume)
;
3.
When the signal disappears during
Delay time
(i.e. the scanning will not
resume if the signal returns within an interval shorter than, or equal to,
Delay Time);
4. When there is no signal during the
Delay time
(i.e. the scanning will
resume if there is a no-signal gap equal to, or longer than, Delay time)
.
The
Delay time
interval can be set from 1 to 100 seconds.
The
Scan rate
controls the speed at which scanning occurs, and specifies
the maximum number of scanning steps per second.