Operating instructions

Setup and How to Operate the Robot

SETUP AND HOW TO OPERATE THE ROBOT

Step # 1

Read and study this manual completely before operating the robot.

Step # 2 Charge the batteries

Be certain that the robot battery and radio control transmitter battery are fully charged before

operating the robot.

Install the robot battery. Open the rear door or trunk to gain access.

1. Put the robot battery in the compartment in the back.

2. Connect the robot battery connector to the robot connector. Red will go to red and black to

black. This connection is polarity protected and can be connected only the correct way.

3. The battery is secured in place with a battery strap. Tighten the strap very tight.

CAUTION

The robot battery posts should never contact the metal of the main electronics box or the

metal of the drive base. This will result in damage to electronic components especially

inside the main electronics box.

Step # 4 Powering up

The radio control transmitter will be referred to as “RC” in this manual.

Turn the RC "ON" first and then turn the robot "ON". Check that the RC

battery level meter reads to the right. The "ON/OFF" switch for the robot is

located inside the rear door or trunk on the main electronics panel. Push the

switch up to turn the robot on.

Step # 5 Set the Volumes

Check that the volume of the voice and tape player are at the level that your want.

The tape player volume can be changed on the tape player itself, which can be accessed

through the rear trunk or door. The volume for the Character voice is on the back of the voice

receiver also accessible through the rear door.

Step # 6 Test all the functions

Test all of the robot's functions: Character’ voice both ways, eyelids, eyes, tape, siren, lights,

and drive movement for proper operation. The robot is now ready to operate.

Step # 7 Optional Accessories Setup

For information about these, see the optional accessories section. This includes options such

as the voice modifier and water squirter. These sections will give you step by step instructions

for setup and related diagrams.

Step # 8 Powering Down

To turn off the system, turn the main switch to the “OFF” position. Finally turn off the Voice

Transmitter, 151 Voice Receiver and the Radio Control Transmitter.