User Manual

Procedure
PleasefollowthesestepseverytimeyouhavetotestaRBOnl38(ABE01):
1. ConnecttheshieldtotheArduinoUnoboard.
2. ConnecttheArduinoUnobyUSBtothecomputer.
3. StarttheArduinoIDEandopentheSerialMonitor(baudrateof9600).
Alternatively,youcanuseanyotherserialinterfacesoftware,suchasPutty.
4. Theexamplecodewilldisplaythevaluesofbothchannels(Strain1&Strain2)every
second.
5. Usingthevaluesdisplayed,adjustthepotentiometers(oneforeachinput)ontheshield
untilthevaluesarearound338(valuesof[323,353]areacceptable).












