Instructions

8585
www.cel-robox.com
7.0 Calibration and Maintenance
AutoMaker™ will now calculate the ‘opening point’ of the valves for each nozzle
in turn. Starting with the nozzles fully closed, you are asked to gradually open the
nozzle until the point when material begins to flow. To open the nozzle further,
keep clicking ‘Not Flowing’ until material appears, and then click ‘Flowing’. This
process is completed first for the fine nozzle and then the fill nozzle.
Ensure both nozzles are clean before proceeding to the next step.
Finally, AutoMaker™ will verify the calibration results by testing extrusion with the
nozzles fully closed and fully open.