Instructions

1111
www.cel-robox.com
Feeding to the Head
Simply feed the end of the filament into one of the two extruder entrances
located in the bottom-le of the reel storage dock. If only one extruder is installed
in your machine, use the top path marked ‘1’. It is much easier to perform this
operation BEFORE installing the reel into the dock.
Once the filament reaches the extruder, you will hear the motor start; at this point
continue to feed in until you feel the filament has been grabbed. Robox® will then
automatically feed the material all the way to the head.
Installing the Reel
Finally, install the SmartReel™ into the dock, you should hear a click when it
is correctly located, and it should appear as a recognised reel in AutoMaker™.
Congratulations! You’re now ready to print.
Hardware Setup