Instructions

1414
www.cel-robox.com
AutoMaker™ Overview
• Fill Density
This setting allows you to choose how ‘solid’ you would like the finished
object to be. The fill pattern can also be changed using a custom profile - for
more information on this, see the User Guide.
90% Fill 80% Fill 70% Fill 60% Fill 50% Fill 40% Fill 30% Fill
• Support Material
This switch toggles the printing of support material. If you are printing a part
with large overhangs, you may wish to print structures at the same time
to support the object. Support settings (e.g. density and type) can also be
changed when using Custom profile - for more information on this, see the
User Guide.
• Brim Width
‘Brim’ is a term applied to FFF (Fused Filament Fabrication) which describes
a large flat area which is printed around the part to help with bed adhesion
and warping. It can be easily trimmed o aer printing, but may greatly
increase the success rate of prints with a small surface area at the base. This
number specifies the number of loops (and therefore the width) of the brim.
Starting Production
Once you are happy with your project layout and settings, you can proceed to
production by clicking the Make! button - watch as your creation appears
before your eyes! AutoMaker™ will provide you with an estimated time to
complete, and a progress bar which shows the percentage completed.
For more information on all aspects of operation - hardware and soware, please
refer to the User Manual which you will find pre-loaded onto the enclosed USB
drive, or to our website, shown below. Happy Manufacturing!