User`s guide

Section INITIAL STARTUP AND MAINTENANCE
Ed. 04/2012 77
kit, taking care to centre the manostat pipe with the hole present on the top edge of
the diaphragm itself (see detail H);
7. refit the exhaust air extractor nozzle to the exhaust fan, taking care to position the
new gasket (supplied) correctly: during this operation, rotate the nozzle so that the
crescent-shaped shield is repositioned in the top half (i.e. as prior to disassembly,
see detail F);
8. reconnect the brass nozzle mount to the mixer, retightening the hexagonal nut,
taking care to replace the previously removed circular seal correctly, supplied as
standard with the kit;
9. retighten the fixing screw of the gas supply pipe above the electrical panel of the
appliance;
10. supply gas and electricity to the appliance, and restart it;
11. regulate the appliance to the pressure indicated in Table 25 on page 75 for the type
of gas to be used, following the instructions provided in Gas flow adjustment
paragraph on page 74; then replace the adhesive label indicating the type of gas for
which the appliance was originally set up with one indicating the type of gas used;
12. complete the change of gas type by checking that all gas connections are sealed,
including those not directly affected by this operation (using soapy water or another
suitable method).
13. refit the left side panel and front panel of the appliance.