User`s guide

Section GENERAL INFORMATION AND TECHNICAL SPECIFICATIONS
Ed. 04/2012 5
EXPLOSIVE/FLAMMABLE MATERIALS HAZARD
Do not use or store flammable materials (paper, solvents, paint, etc.) in the vicinity
of the appliance.
SUGGESTIONS FOR THE CLIENT
Stipulate a maintenance contract with an authorised specialist contractor for the
annual inspection of the appliance and maintenance when needed.
Maintenance and repairs may only be done a contractor legally authorised to work
on gas appliances and equipment.
Only accept and use original spare parts.
1.2 GENERAL INFORMATION
Conformity to CE standards
This manual is an integral and essential part of the product and must be given to the end
user along with the ACF.
The ACF is certified according to EU standards and conforms to the basic requirements of
the following regulations:
Gas directive: 90/936/CEE
Electromagnetic compatibility directive 89/336/CEE
Low voltage directive 73/23/CEE
Pressurized Equipment Directive (PED) 97/23/CEE
The operational conditions and authorized areas of use are reported in paragraph 1.4
TECHNICAL SPECIFICATIONS on page 11.
Installation and regulatory references
When the appliance arrives at the installation site, before beginning the stages requi-red
to move it in order to position it on the site, perform a visual check to ascertain that there
are no evident signs of breakage or damage to the packaging or to the external panels,
which would be signs that damage occurred during transport.
Packing materials must be removed only after the appliance has been positioned
on site. After removing the packing materials, ensure that the appliance is intact
and complete.
Installation of the appliance may only be carried out by firms that are qualified in
ac-cordance with current legislation in the country of installation, i.e. by professionally
qualified personnel.
“Professionally qualified personnel” means personnel with specific technical
compe-tence in the sector of heating/cooling plants and gas appliances.
Installation of the appliance must be carried out in compliance with current local and
national regulations regarding the design, installation and maintenance of heating and
cooling plants in accordance with the manufacturer's instructions.
In particular, the following current laws must be respected with regard to: